Unfortunately, there is no simple way to determine which length of Webber you will need based on your
leg length
or your
current stirrup strap length
This is due to a number of factors such as saddle flap length and shape, and how you personally prefer the length for the different disciplines you participate in.
How is stirrup Webbers measured?
-
Measure the length of your arm from your armpit to the tips of your fingers for jumpers. Or inseam of your leg to the
ankle bone
for
dressage riders
. - Double the measurement.
- Add a couple of inches for jumpers, or 6-8 inches for dressage riders.
What are Webbers on a saddle?
Bates Leather Webbers are revolutionary stirrup straps made without buckles to reduce the lump under the riders thigh and provide closer contact to the horse The single thickness under the leg removes excess bulk and interference, facilitating the accurate delivery of leg aids..
What are
webber stirrup leathers
?
Description. The Webbers are designed to reduce bulk under the riders leg, by using a single length of English leather with a bonded nylon core The strap has a loop at one end to go over the stirrup bar, and is adjustable at the other.
How do I launch Webbers?
How do I run-up my WEBBERS when they are not in use? At the very top of the WEBBERS near your stirrup bar, there is a run-up-hole. Simply lift up the sleeve, unbuckle your WEBBERS, run your stirrup iron up, and re-buckle your webbers into the run-up-hole as shown.
What are Webbers horses?
What are WEBBERS? Bates Leather WEBBERS are a simple and elegant solution to the uncomfortable lump of our stirrup leathers under our leg As riders, the lump of stirrup leathers under our leg is something we have just come to accept, but WEBBERS do away with the lump completely. WEBBERS just make so much sense ….
What length stirrup leathers do I need 5 8?
For jumping disciplines, the average adult takes 54 inch stirrup leathers. A rider who is short in height may do best with shorter length leathers, from 48 to 52 inch lengths. A tall rider may require a 56 inch length.
How do I know what size stirrup I need?
The base is surrounded by a loop which helps to keep the foot securely in place. What Size Stirrup Irons Do I Need? In general, the rule is that your stirrup irons should be one inch wider than the width of your boot at the ball of the foot , giving you a half inch of room on either side when in the stirrup.
What is a stirrup strap?
n. 1. A flat-based loop or ring hung from either side of a horse’s saddle to support the rider’s foot in mounting and riding ; a stirrup iron.
What is a total contact saddle?
The Total Contact Saddle (TCS) is a treeless saddle that wraps around the horse It fits the shape of the horse – all year, in all conditions, all breeds and all conformations. For the first time, one saddle really does fit all shapes and sizes! The TCS concept.
How long should my stirrups be for jumping?
The most commonly cited guideline is to have the bottom of the stirrup hit mid-ankle bone for jumping small jumps. If you are going to be focusing on flatwork, you may be more comfortable in longer stirrups, adjusted to just below your ankle bone.
How long should my stirrups be for dressage?
A good starting point is to go one hole longer than the ankle initially Eventually, you’ll probably end up with your stirrups level with the bottom of your boot. In the early stages though, making your stirrups too long will make your leg swing as you “reach” for the stirrups and try to stand up in them.
What size are Wintec Webbers?
Wintec Webbers are available in three lengths, which we simply refer to as 0, 1 and 2, however we have put some measurements below as a guide for you: Size 0 (60 cm or 24″) Size 1 (70 cm or 28″) Size 2 (80 cm or 32″).
Should you oil stirrup leathers?
The leathers wear better and don’t need oil It should be obvious that riders need to switch their stirrup leathers about monthly. Even if you use a mounting block of some type and don’t overstrain your left leather that way, most of us still put more weight on one side.
What happens if your stirrups are too short?
The stirrups should not be so short that your knees begin to hurt. (unless of course you’re a racing jockey.) This can cause knee pain in the long term and naturally causes you to tip forward in the saddle, throwing your alignment off balance.
Do wide stirrup leathers work?
“ Stirrup leathers just got a whole lot better The Stability Stirrup Leathers wide-body design brings an unprecedented level of stability to a rider’s leg, while at the same time creates a smoothness on the flap that makes them disappear under the leg.”.
What kind of stirrups should I get?
The most traditional types of stirrups are the Fillis, which are manufactured in varying grades of stainless steel and available in a range of prices. For many riders, simple Fillis irons are a good choice. Their classic appearance makes them popular, acceptable and affordable for both casual riding and the show ring.
What is the purpose of a stirrup hobble?
Stirrup hobbles help maintain the turn of the stirrup leathers Stirrups should always hang at a 90 degree angle to the fender so that your feet can slip easily into them, and these straps will hold them in that position.
What are fender hobbles?
Barefoot Fender Hobble Straps Place these tightly around the bottom of your fender extensions to hold them together with your stirrup leathers This helps prevent the rider from catching a foot in between, and possible getting hung up. They are an important safety feature and should always be used when riding.
References
https://www.doversaddlery.com/wintec-webbers/p/X1-0632/
https://marystack.com/wintec-webbers/