Where Are Driftmaster Rod Holders Made?

We make our products in Manning, South Carolina “Made in the USA” means something to us. Hopefully this web site will make it easy to rig your boat for the way you want to fish. If you have any questions, please call us at 803-473-4927.

Which

rod holder

is best?

  • Best Overall: Scotty Power Lock Rod Holder at Amazon
  • Best Design: STEALTH Fishing Rod Holder at Amazon
  • Best Clamp-On: PLUSINNO Fishing Boat Rod Holder at Amazon
  • Best Rail-Mount: Brocraft Rail Mount Rod Holder at Amazon
  • Best Sand Spike: Fish-N-Mate Sand Spike at Amazon.

Are Cannon rod holders good?

Cannon rod holders are extremely secure , featuring a locking pin on the inside to keep your rod exactly where you set it and hold it in place even if you’re traveling over rough water.

What size are rod holders?

Common sizes are 1 5/8 and 1 7/8-inch (inside diameters) and 2 or 2 1/4-inches (outside diameter) Before making any purchasing decision be sure the inside diameter isn’t too narrow. A slick-butt trolling rod may fit perfectly, but a spinning rod with a thick cork or foam butt may not fit at all.

Where do rod holders go on a boat?

To make it easy to fish while you’re steering the boat, place the rod holder at a 90-degree angle from the centerline , making sure the area under the gunwale is free of wires and other potential obstructions.

What size PVC should I use for fishing rod holder?

In order to learn how to make sand spike rod holders we’re going to need a schedule 40 PVC pipe (size found in red on the side of the pipe as “SCH 40”) in a 1-1/2 inch width (also found on the side of the pipe). This is an important size to have because it will fit most of your fishing poles right in the end of it.

What size PVC fits in rod holders?

A 2-foot length of 1 1/4-inch PVC wedges snugly into a rod holder.

Do you need a rod holder?

Fishing rod holders are an integral part of a fishing boats setup, and for very good reason. The most

obvious use

is for trolling Whether it is with a downrigger or when flat lining, a rod holder can be a godsend during long, punishing days on the water, and also during nasty and extreme weather.

How long are surf fishing rod holders?

Available in three lengths, 2-, 3, and 4-feet , if you drive the longest of these a few feet into wet sand, a fish would need to break the PVC to tear it loose, and that’s pretty unlikely unless you hook something massive.

How long are sand spikes?

This 50″ long, 1/8 x 1.5 angle sand spike is made of non-corrosive aluminum anodized finish. Foot push for ease of use in and out of the sand.

How far apart should rod holders be?

End of dialog window. I’m currently having a rocket launcher built and the fabricator said standard spacing is 9.5

inches center

to center To clearInstall them were you like. most offshore reels from each other,9″ center to center.

What angle rod holder do I need?

15-Degree Rod Holders The 15-degree rod holder is the most popular option because you can put it in any location on the boat, except for the transom. For the best results, put it on the corner of the transom and the side of the boat, ensuring that it is angled away from outboard motors.

How do I organize my garage fishing rod?

Secure gravity hooks or vertical bike hooks to the wall of the garage. Use storage bins as the base and store your poles vertically against the wall. Buy a pre-made fishing rod rack and store it inside a garage cabinet to keep it away from humidity, sunlight, and falling objects.

References


https://www.westmarine.com/fishing-rod-holders/driftmaster


https://www.captmacks.com/store/product-category/fishing-accessories/rod-holders/driftmaster-rod-holders/